Differences

This shows you the differences between two versions of the page.

--- 3d_printer [2023/03/24 10:44] – [Filament Selection] Berkhout, J.T. (Julian, Student B-EE)
+++ 3d_printer [2024/12/03 09:58] (current) – [Nozzle Selection] Berkhout, J.T. (Julian, Student B-EE)
@@ Line 16: / Line 16: @@
 ===== Nozzle Selection =====
-There are multiple types of nozzles but for most use cases 0.4AA is the standard. If you want to make a large part that does not need to be super precise use the 0.8AA nozzle and for a very precise print use 0.2AA. if you want to use water soluble PVA supports use one of the BB nozzles as these are optimized for that filament. To swap nozzle just open the printhead and swap them. It might tell you to calibrate xy axis with a new combination of nozzles. Refer to the appendix for this (STILL TO DO)
+There are multiple types of nozzles but for most use cases 0.4AA is the standard. If you want to make a large part that does not need to be super precise use the 0.8AA nozzle and for a very precise print use 0.2AA. if you want to use water soluble PVA supports use one of the BB nozzles as these are optimized for that filament. To swap nozzle just open the printhead and swap them. It might tell you to calibrate xy axis with a new combination of nozzles, find the accompanying paper in the drawer underneath the printer. [[https://support.makerbot.com/s/article/1667411154180|Calibration manual]]
 ===== Print Settings =====
@@ Line 26: / Line 26: @@
 Remove the glass printbed and set it down on the drawer table. Remove the entire print and break away the supports if you use breakaway filament or soak in water for some time if you used PVA. Use files and clippers for final cleanup
+===== User Manual =====
+For more information, please check the [[https://medialibrary.uantwerpen.be/files/1073/83881a0f-3929-472f-a4eb-a6725bab004f.pdf|User Manual]]